Honda ► XL80S ►
-
Here’s our hand-picked list of electrical parts for your Honda XL80S with universal parts included that match “honda sl125”►
- Honda
Condenser
Condenser Replaces OEM # 30250-041-005 / 30250-035-005 Hitachi Type
Front Reflector
Front Reflector, Replaces OEM# 33742-HB9-641 / 33741-413-003 / 33741-413-013 Amber Reflector with Black Plastic Ring. 2 Segments in the Reflector (Instead of 6 Like the OEM).
Contact Point
Contact Point, Replaces OEM# 30202-041-015 Note: These are for Hitachi type ignitions only NOT Mitsubishi type. Please check which type of ignition you have before ordering.
Tail Light Lens
Tail Light Lens, Replaces OEM# 33702-MC4-671 / 33702-MGR-305
Battery Box Rubber
Battery Box Rubber, Replaces OEM# 83618-323-000 Sold Each, Order the Quantity you Require
Front or Rear Turn Signal Lens
Front or Rear Turn Signal Lens, Replaces OEM# 33402-166-003 / 33402-195-023 / 33402-195-013 / 33402-195-003 Note: These Lenses Clip On, They are Not Fastened By Screw Like the Original Lenses Sold Each, Order the Quantity you Require.
Contact Point
Contact Point, Replaces OEM# 30202-041-005 / 30202-035-005 / 30202-041-015 / 207-81321-90 / 32240-12020
Tail Light Lens
Tail Light Lens, Replaces OEM# 33702-MC4-671 / 33702-KB7-003 / 33702-KB7-013 / 33702-MGR-305 / 33702-GF4-000 / 33702-MG2-942 This Tail Light Does Not Have Reflectors on the Sides of the Lens.
Starter Clutch Diode
Starter Clutch Diode OEM Ref # 31700-124-003 / 31700-166-008
Hydraulic Brake Light Switch
Hydraulic Brake Light Switch Banjo Bolt Type - 10mm x M1.25 Can Be Used Front/Rear At Single Banjo Brake Line Fitting Correct Thread For Most Honda/Kawasaki/Yamaha Stock Fittings
Universal 1 Ohm Dual Output 6V Ignition Coil
Universal 1 Ohm Dual Output 6V Ignition Coil. Will work on a number of Honda, Kawasaki, Suzuki, Yamaha, Norton, BSA, Triumph and other motorcycles with 6 volt dual output ignition coils. Check the coil mount spacing on your bike before you order. Mounting holes are 90mm (3.5") apart center to center. Low tension wires 390mm (15") long. Female spade connectors at the coil and male and female bullet connectors at the other ends. Spark plug wires (high tension leads) 570mm (24") long with 300mm (12") protective sheath.